All the equipment that is repaired or that goes through our Refurbishing Department is subject to a strict inspection process.

This is a brief explanation of the remanufacturing process .

For further information, we invite you to go to our office in Miami where we will be happy to assist you.

Line Equipment Remanufacturing.

Selection

The line gear equipment is received at the remanufacturing department where their lids are removed, inspected, and discarded if there is any damage caused by water, short circuiting, or physical imperfections. After being selected, all the needed accessories* are installed.

* Accessories: (Fuses, attenuators, equalizers, bodes, MDR, LDR, Jumpers, hybrids, filters, optical transmitter and receivers, etc...…) .

Performance Tests

After being selected and adding all its accessories, the line gear must then pass a few tests to ensure that the performance of the equipment complies with the manufacturer's specifications, both in the forward and reverse signals.

Note: equalizers and attenuators used to test the equipment are at 0dB, in order to assess the performance of the equipment at its maximum gain.

Checking the level of voltage Teams Line

Line gear with internal power supplies included are tested in order to establish the voltage of the alternating and direct current (AC/DC); at the same time making sure they meet the requirements set forth by the manufacturer.

If the line gear does not have its own power supply, it is hooked up to an external power supply and its AC and DC are tested according to manufacturer specifications.

After satisfactorily passing these tests, the line gear is then tested with an audio and video program modulated to simulate its work in the field.

Customizing line gear

Following the tests, the line gear equipment proceeds to an area of personalization where they are prepared according to customer specifications.

Example: (attenuators, equalizers, jumpers, TDU, ADU, ACB Monitor, optical transmitters and receivers, etc. ...) .

Housings are added, at the customer’s request, using the inserts required by the manufacturer.