Remanufacturing the Line Gear Power Supply

The power supply is connected to the corresponding amplifier where its AC/DC voltage is verified according to manufacturer specifications.

After passing the tests a security seal is applied.

Remanufacturing of the Power Supply Network

Power Supply without standby
The power supply is connected to an input of 110 Volts and the output AC voltage is verified according to manufacturer specifications.

After passing the tests a security seal is applied.

Power Supply with stand-by
The corresponding batteries are connected (the battery voltage varies with model).

Next, the power supply is connected to 110 Volts in order to measure its output voltage when it is connected and when there is an interruption in the 110 Volts of energy. The measure of the output voltage in both cases should be the same, since it should maintain a stable signal when the change is made and there is an interruption in the voltage. (the output on these power supplies vary depending on the model).

Finalizing
Having passed all the tests during the process of remanufacturing and/or repair, the equipment are sealed with a safety and security seal. These specify the order number and technician who supervised the process along with the date the equipment was tested.